Step 1
Pre clean and dry surface to ensure it is free from dust and grease. Place masking tape either side of the sticker half way up to hold in position. IMPORTANT: To ensure that your decals last for as long as possible on your vehicle please avoid aggressive washing with a jet wash or car wash brushes. Any lifting of the edge of the decal can cause the decal to lift off the surface of your vehicle which will cause peeling.
Step 2
Peel the sticker and application film to the tape in the middle.
Step 3
Using scissors cut away the newly revealed backing paper and apply the top part of the design to the wall. Repeat the process for the bottom half of the design.
For smaller stickers it may not be necessary to cut the backing paper in two parts.
Step 4
Using a credit card firmly rub and apply the sticker to the wall, focusing primarily on the sticker design. Repeat with the second half. Wait about 30mins to allow the adhesive to bond.
Step 5
Peel back the edge of transfer film & remove by pulling slowly and carefully away at 180 degrees to vinyl. Make sure non of the vinyl pulls up with the transfer film. If so simply rub over with a credit card to allow the transfer paper to re-attach to the vinyl sticker.
Step 6
Make yourself a cup of tea and admire a job well done.
N.B. Please follow these instructions carefully as we cannot be held responsible for incorrectly applied stickers and damage to paintwork through incorrect application. Above all – please take your time!
